Another Tuesday, another productivity-enhancing, time-saving, finger-snapping AutoCAD tip. This one features AutoCAD model space viewports. These are tiled viewports often used to view a 3D model from different angles in model space; they are very different from their paper space viewport counterparts.
As always, to get all the AutoCAD Tuesday tips in this series, and many more, simply register to download my “best of” AutoCAD and AutoCAD LT tips book.
The model space viewports of the past were pretty structured. We had limited control over their size and position. And adding additional tiled viewports was a bit of a chore.
Now model space viewports are easier to identify, resize, and add. Simply drag the horizontal or vertical viewport boundaries, or drag the intersection to resize many at one time. Done!
Use the “+” icon to easily add more viewports … just click and drag the icon, then release when you’ve got it at the proper size.
You can also create a new viewport by holding the Control key while dragging.
Bonus tip! Join or remove a viewport by dragging a boundary to the edge. It’s just that simple!
Want to learn more about AutoCAD model space viewports?
If I’ve whet your appetite for more information about model space viewports, visit the following pages on the Autodesk Knowledge Network ….
Want to learn more about using AutoCAD?
Whether you’re an AutoCAD newbie or a grizzled veteran, take a few minutes to check out the page full of amazing AutoCAD resources we’ve gathered especially for new AutoCAD subscribers.
AutoCAD Tuesday Tips with Lynn: The Adventure Continues ….
- Last week’s AutoCAD Tuesday tip with Lynn … AutoCAD Block Galleries: View and Insert from Ribbon
- Next week’s AutoCAD Tuesday tip with Lynn … AutoCAD Layouts: Easier to Access and Add
Can’t wait a week for your next tip? I completely understand! Now you can get 60+ tips all at once when you register to download my “best of” AutoCAD and AutoCAD LT tips book.
There are no comments